Overview
|
Arduino 4 릴레이 쉴드는 컨트롤러의 전류 및 전압 제한으로 인해 Arduino 디지털 IO로 제어 할 수 없는 고전력 부하를구동하는 솔루션입니다. Shield에는 4 개의 릴레이가 있으며 각 릴레이는 2극 전환 접점 (NO 및 NC)을 제공합니다. 각 출력의 전류 제한을 증가시키기 위해 2 개의 전환 접점이 병렬로 배치되었습니다. 네 개의 LED는 각 릴레이의 on/off 상태를 나타냅니다
|
Summary
|
Operating Voltage
|
5V
|
Coil current consumption
|
140 mA (with all releays on, about 35 mA each)
|
Single pole chargeover contact maximum current
|
@ 30 V DC 2A
|
Maximum load voltage
|
48 V
|
Maximum switching capacity
|
60 W
|
|
Schematic & Reference Design
|
|
Power
|
- 실드는 외부 전원이 필요하지 않고, 베이스 보드에서 제공되는 Arduino 보드의 5V 및 3.3V 핀을 통해베이스 보드에서 제공됩니다.
|
Input and Output
|
-
릴레이는 다음 Arduino 보드에 의해 제어됩니다
- Relay 1 = Arduino pin 4
- Relay 2 = Arduino pin 7
- Relay 3 = Arduino pin 8
- Relay 4 = Arduino pin 12
이 실드는 TinkerKit 입출력과 통신 인터페이스를 특징으로 하고, TinkerKit 모듈을 연결하면 프로젝트 또는 프로토 타입을 간단하게 작성할 수 있습니다
온보드 커넥터는 다음과 같습니다 :
- 2 TinkerKit Inputs: IN2 and IN3 (in white), these connectors are routed to the Arduino A2 and A3 analog input pins.
- 2 TinkerKit Outputs: OUT5 and OUT6 (in orange), these connectors are routed to the Arduino PWM outputs on pins 5 and 6.
- 2 TinkerKit TWI: these connectors (4-pin in white) are routed on the Arduino TWI interface. Both connect to the same TWI interface to allow you to create a chain of TWI devices.
|
Physical Characteristics
|
- 4개의 릴레이 실드 PCB의 최대 길이와 너비는 각각 2.7과 2.1 인치로, 네 개의 나사 구멍으로 실드를 표면이나 케이스에 부착 할 수 있습니다. 디지털 핀 7과 8 사이의 거리는 160mil (0.16 ")이며 다른 핀의 100mil 간격의 배수가 아닙니다.
|
Compatibility
|
- 실드는 모든 Arduino 보드, 5V 및 3.3V 표준과 호환됩니다.
|